| Notes on coolant Observe the notes on operating fluids. 
	
		| WARNING ‑ Risk of fire and injury from
		antifreeze |  
		| If antifreeze comes into contact with hot
		component parts in the engine compartment,
		it may ignite. 
			Allow the engine to cool down before
			adding antifreeze.Make sure that no antifreeze spills out
			next to the filler opening.Thoroughly clean off any antifreeze
			from component parts before starting
			the vehicle. |    
	
		| NOTE Damage caused by incorrect coolant |  
		| 
			Only add coolant that has been premixed
			with the required antifreeze protection. Information on coolant is available at the following
		locations: 
			In the Mercedes-Benz Specification for
			Operating Fluids 310.1
				At 
				http://bevo.mercedes-benz.comIn the Mercedes-Benz BeVo appAt a qualified specialist workshop |    
	
		| NOTE Overheating at high outside temperatures |  
		| If an inappropriate coolant is used, the
		engine cooling system is not sufficiently protected
		against overheating and corrosion at
		high outside temperatures. 
			Always use coolant approved by
			Mercedes-Benz.Observe the instructions in the
			Mercedes-Benz Specifications for Operating
			Fluids 310.1. |  Have the coolant regularly replaced at a qualified
specialist workshop. 
The proportion of corrosion inhibitor/antifreeze
concentrate in the engine cooling system should
be: 
	a minimum of 50% (antifreeze protection down to approximately -35 ºF 
	(-37 ºC) )a maximum of 55% (antifreeze protection down to -49 ºF (-45 ºC) ) Coolant capacity 
 Notes on windshield washer fluid Observe the notes on operating fluids. 
	
		| WARNING ‑ Risk of fire and injury from
		windshield washer concentrate |  
		| Windshield washer concentrate is highly
		flammable. It could ignite if it comes into
		contact with hot engine component parts or
		the exhaust system. 
			Make sure that no windshield washer
			concentrate spills out next to the filler
			opening. |    
	
		| NOTE Damage to the exterior lighting
		due to unsuitable windshield washer fluid |  
		| Unsuitable windshield washer fluid may damage
		the plastic surface of the exterior lighting. 
			Only use windshield washer fluid which
			is also suitable for use on plastic surfaces,
			e.g. MB SummerFit or MB Winter‐
			Fit. |    
	
		| NOTE Blocked spray nozzles caused by
		mixing windshield washer fluids |  
		| 
			Do not mix MB SummerFit and MB WinterFit
			with other windshield washer fluids. |  Do not use distilled or de-ionized water as the fill
level sensor may be triggered erroneously. 
Recommended windshield washer fluid: 
	Above freezing point: e.g. MB SummerFitBelow freezing point: e.g. MB WinterFit For the correct mixing ratio, refer to the information
on the antifreeze container. 
Mix the washer fluid with the windshield washer
fluid all year round. |